I have an ecs k7s5a rev 1.0 that has a similiar problem. After I switched to
DDR PC 2700 RAM (Crucial, 2 DIMMS 256 MB each). I get a video signal when I
install a new card, but when I reboot or shut down and restart, no video. It
worked fine with 2 256 crucial SDRAM sticks, but since the change in memory,
I can't get a viseo signal after first boot. I have the latest official
release bios installed ( I forget the number as I can't see it!!) The cards
I have tried are an older Matrox 8 MB PCI and an ATI Radeon 7000 AGP.

As a followup, I cleared CMOS and ran at 100FSB, I have no video problems.
When I run it at FSB 133, (with an Athlon XP 2000 Palamino, memory also at
133), no video at all, I must clear CMOS again to get video and revert to
100 FSB...

Any suggestions?


Thanks

Mark wrote:



--
The e-mail address in our reply-to line is reversed in an attempt to
minimize spam. Our true address is of the form che... (AT) prodigy (DOT) net.