I recently refilled my cartridges, something I have done dozens of times. I
have the
Epson RX500 with 6 color cartridges. One color kept coming out with broken
lines
on the 'cleaning and print' mode, even after 8 cleanings. I put in a new
cartridge, but
the problem persists. Is there something else that needs to be cleaned that the
Epson
cleaning program doesn't address?

The cleaning mode really sucks up the ink. My 8 repetitions indicated that half
the
ink in my refilled cartridges was used up by that operation.

Sherwin D.

It is rarely good value to do more than 3-4 cleanings maximum. As you
stated it wastes a heck of a lot of ink, for little to no benefit.

If you email me at the address shown below, I will gladly send you a
manual I have written with procedures for resolving more head clogs for
Epson printers.

Ask for the Epson Cleaning Manual. Indicate the printer you are using.
There is no charge for the manual and you will neither be solicited or
spammed or will I suggest any proprietary products.

e-printerhelp(at)mvps(dot)org

(at) = @
(dot) = .

Art

sherwindu wrote:

Finally got an email reply from Epson Customer Support (after 3 days), and it read
like a piece of boiler plate, warning me not to use third party ink The last piece
of
advice they gave me was that if the clean cycles didn't work, send the printer in
for
repair. Right now, I have only one color giving proplems. I have ordered a
cleaning
cartridge from Atlantic Ink, and that hopefully will cure the problem. Thanks for
the
helpful replies.

Sherwin D.



sherwindu wrote: